USB Common Driver

For Windows 10

Download USB Driver (5098893, Rev. C1)

Installation guide

• Install Kamstrup USB Driver.exe
• Connect the Kamstrup USB product when the driver installation is finished.

The USB driver is to be used with the following products:

• Optical eye with USB
• 3-wire cable with USB
• USB configuration cable for H/C modules
• USB cable for MULTICAL 402 with galvanic separation
• USB cable for ULTRAFLOW x4 METERTOOL
• M-Bus Master 250

For Windows XP with Service Pack 3, Windows Vista, Windows 7 and Windows 8

Download USB Driver (5098893, Rev. B1)

Installation guide

• Install Kamstrup USBCommon Driver.exe
• Connect the Kamstrup USB product when the driver installation is finished.

The USB driver is to be used with the following products:

• Optical eye with USB
• 3-wire cable with USB
• USB cable for MC 402 with galvanic separation
• USB cable for ULTRAFLOW x4 Metertool
• M-Bus Master 250

Software for Kamstrup USB interface

For Windows 98/2000/2003 and Windows XP (without Service Pack 3)

Download: Driver (5098282, Rev. D1) for Kamstrup USB Interface (optcal/3-wire) zip-fil (15 MB)

Please read below before downloading drivers and installing the Kamstrup USB unit (optical or 3-wire)!

The zip-file contains the same files as the original Kamstrup USB Driver CD, and it is possible to make a Kamstrup USB Driver CD just by burning the unzipped files on a blank CD-Rom.

To install Kamstrup USB Interface:
1. Download the zip-file
2. Unzip the file in an emply folder

Windows 98/2000/2003
3. Run Intro.exe
(4a. If you need any help select "Installation Guide")
4. Select "Install USB Driver" from the menu
5. Connect the Kamstrup USB unit when the driver installation is complete.

(Note! The information "Found new hardware"- will pop up twice when the Kamstrup USB Unit is inserted. This is normal).